Setting the Primary Marker

Each Series C swivl robot comes with three markers. One of these must be set as the primary marker

If Swivl App doesn't  display a Primary marker, you must follow the procedure below to re-set the base.

Re-Setting the Primary Marker (step-by-step)

  1. Set up your Swivl with your mobile deviceand open the Swivl app.
  2. Plug the Swivl robots wall charger into an outlet and plug it into the base.
  3. Turn on the base by holding down the power button for a few seconds (LEDs will light up to indicate base is on).
  4. Press and hold the pairing (+) button, then tap the base power button 4 times, then release the pairing (+) button.
  5. The pair LED will blink for a few seconds to confirm.
  6. Dock the marker you want to set as the Primary Marker in the base. The pair LED will blink for a few seconds to confirm pairing. Once pair LED has turned solid, remove the Marker from the base and turn it on. Follow the on-screen instructions to pair it.
  7. Pair any Secondary Markers you have as described here.

Once the primary marker is set, you may also want to re-set the secondary markers.

0 Comments

Add your comment

E-Mail me when someone replies to this comment